The Honeywell RTH5160D1003 is a non-programmable thermostat for conventional forced air, heat pump, radiant heat and cool-only systems. It mounts on the UWP Mounting System and runs on two AA alkaline batteries. The Quick Installation Guide, document 33-00200EF-01, carries 19 numbered steps, from turning the power off at the breaker to the System Setup numbers.
Download / Preview Manual
32 pages: English on pages 1 to 16, then the French version on pages 17 to 32.
Honeywell RTH5160D1003 Product Specifications
| Specification | Details |
|---|---|
| Brand | Honeywell |
| Model | RTH5160 Series (D1003 is the catalog number; the PDF prints only the series name) |
| Product Type | Non-programmable thermostat |
| Screen | Home screen; Menu, Next (+) and Edit (-) buttons; alert icon and alert number shown on screen |
| System Types | Conventional forced air, heat pump, radiant heat (boiler), cool only |
| Stages | Up to 2 cool stages or 1 compressor stage; up to 2 heat stages, 1 aux/E stage |
| Power | Two AA alkaline batteries. C does not power the thermostat display or operations; batteries are always required. |
| Terminals Not Supported | L/A, S, U |
| Mounting | UWP Mounting System, three #8 1-1/2 in. screws, 7/32 in. drill bit |
| Document | 33-00200EF-01, 32 pages, PDF |
| Warranty | 1 year limited, excluding battery |
Frequently asked questions
Q: Does the RTH5160 need a C wire?
A: Not for power. C does not power the thermostat display or operations; batteries are always required. When the old labels do not match the new terminals, a single C or C1 wire goes to the C terminal; if there are two, wrap each separately with electrical tape and do not connect them.
Q: What batteries does it take?
A: Two AA alkaline batteries. The low battery icon appears about two months before the batteries are depleted, and the batteries should be replaced once a year even if the icon does not appear.
Q: Why is the display blank?
A: Make sure fresh AA alkaline batteries are properly installed, as shown on page 7.
Q: Why can’t I change the system setting to Cool?
A: Check System Setup Option 220 and make sure it is set to 1 or 2, as described on page 9.
Q: What does it mean when Heat On or Cool On flashes?
A: Compressor protection feature is engaged. Wait 5 minutes for the system to restart safely, without damage to the compressor.